Lenze EtherCAT Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 73)

Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17 73

7 Commissioning of the system

7.3 Detailed description of the commissioning steps

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.3.7 Configuring the communication parameters

Set the communication parameters in order to be able to carry out a fieldbus scan at a later time or

in order to be able to establish an online connection to the Lenze Controller .

 How to configure the communication parameters

1. Go to the Communication settings tab of the target system (device) and click the Add

gateway button.

Then go to the Gateway dialog box and enter the IP address of the controller. (By

double-clicking the predefined value it can be overwritten.)

2. Confirm the entry by clicking OK.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 204 205

Pas de commentaire

Lenze EtherCAT Controller-based Automation Manuel d'utilisateur Page 73