Lenze EtherCAT Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 163)

Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17 163

12 Diagnostics

12.1 Diagnostics with the »PLC Designer«

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

12 Diagnostics

This chapter provides information on diagnostics using the »PLC Designer« and the »WebConfig«.

Moreover, error scenarios for the most frequent user errors are shown and system error message are

described.

12.1 Diagnostics with the »PLC Designer«

A test project in which the diagnostic functions of the Function library L_IODrvEtherCAT.lib ( 110)

are used, can be found in the download area at www.lenze.com:

Application Knowledge Base: All articles  Application Ideas Pool  Controller 3200 C

12.1.1 Representation in the online mode

When an online connection has been established to the Lenze Controller, the icon in front of the

individual entries in the configuration tree provides information on the status of the respective

EtherCAT node (in the example: two green arrows in each case):

Icon Meaning

Device is online

• Successful online connection to the Lenze Controller

• Successful online connection to the EtherCAT node.

• Status of the node: Operational (OP)

Device is online

Possible states of the EtherCAT node:

• INIT (initialisation)

• PREOP (Pre-operational)

• SAFEOP (Safe-operational)

• No information on the node

no icon Device is offline

• No connection to the Lenze Controller

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 204 205

Pas de commentaire

Lenze EtherCAT Controller-based Automation Manuel d'utilisateur Page 163