Lenze EtherCAT Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 71)

Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17 71

7 Commissioning of the system

7.3 Detailed description of the commissioning steps

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.3.6 Creating a PLC program with a target system (Logic/Motion)

By means of the »PLC Designer« you can map the network topology in the control configuration.

 Tip!

In »PLC Designer«, EtherCAT nodes as well as nodes of other fieldbus systems can be

configured.

Mixed operation - EtherCAT with other bus systems

( 106)

 How to create a PLC program in »PLC Designer«

1. Use the menu command File  New project to create a new »PLC Designer« project.

2. Select "Standard project" in the New project dialog box.

A "Standard project" simplifies the structure of a project in the »PLC Designer«; for instance,

a device tree structure with a target system, PLC logic, etc. is provided.

• Go to the Name input field and enter a name for your »PLC Designer« project.

• Select the previously created project folder as storage location in the Location

selection field.

Create a project folder

( 43)

3. Confirm the entries by clicking OK.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 204 205

Pas de commentaire

Lenze EtherCAT Controller-based Automation Manuel d'utilisateur Page 71