Lenze PLC Designer R3-x Manuel d'utilisateur télécharger pdf (Page 57)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014 57

Extending sample projects - adding devices

Create control configuration - bus system CAN

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

5. Use the command Add Device to add a Logic device (slave) to the CANopen_Manager

(master).

Select the desired CAN node from the selection list.

Tip!

For the implementation of other controllers, a general device description is provided: Lenze

Generic Drive.

Further information on the function block of the general device control can be found in the

following section: L_LCB_GenericDrive

( 130)

Repeat the Add Device command until all slaves connected to the bus are

implemented in the control configuration. Optionally, you can Copy and Paste a node

already inserted into the context menu of the device. The communication settings (node ID

and baud rate as well as further parameters) must be adapted manually.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 158 159

Pas de commentaire

Lenze PLC Designer R3-x Manuel d'utilisateur Page 57