Lenze PLC Designer R3-x Manuel d'utilisateur télécharger pdf (Page 40)

Working with the sample projects

Sample project with "Table positioning" application - TablePositioning

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.2.4 Open the »Engineer« project & go online

 How to open the sample project in the »Engineer«:

1. Start »Engineer«.

2. Open the desired project (CAN or EtherCAT) using the FileOpen archive command.

3. Insert the desired motor in the configuration:

• Highlight controller, select the desired motor with the command Insert a component on the

Motors tab

• By clicking Complete, insert the selection in the »Engineer« project.

 Detailed information on the general handling of the »Engineer« can be found in the

online help for the »Engineer«, which you can call with [F1].

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 158 159

Pas de commentaire

Lenze PLC Designer R3-x Manuel d'utilisateur Page 40