Lenze PLC Designer PLC Designer (R2-x) Manuel d'utilisateur télécharger pdf (Page 712)

100

101

L-force | PLC Designer

PLC Designer Visualization

710 DMS 3.2 EN 02/2011 TD29 

20.6.12 Motion relative

In the dialog for configuring visualization elements in the Motion Relative category,

you can assign variables to the individual element edges. Depending on the values of

the variables, the corresponding element edges are then moved. The easiest way to

enter variables into the fields is to use the Input Assistant (<F2>).

The four entries indicate the four sides of your element. The base position of the

corners is always at zero. A new value in the variables, in the corresponding column,

shifts the boundary in pixels around this value. Therefore, the variables that are

entered ought to be INT variables.

 Note!

Positive values shift the horizontal edges downward, or, the vertical edges, to the

right!

In online mode the variables which are set in the 'Motion absolute' dialog will

override the values of structure components which additionally might be used to

define the same property ('Programmability').

In case of multiple definition of an element property consider the specific order of

precedence concerning according to which a value might be overwritten in online

mode by another.

Dialog Box for Configuration of Visualization Elements (Motion Relative Category)

1 2 ... 707 708 709 710 711 712 713 714 715 716 717 ... 843 844

Commentaires sur ces manuels

Pas de commentaire

Lenze PLC Designer PLC Designer (R2-x) Manuel d'utilisateur Page 712

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Lenze PLC Designer PLC Designer (R2-x)