Lenze PLC Designer PLC Designer (R2-x) Manuel d'utilisateur télécharger pdf (Page 376)

L-force | PLC Designer

The Resources

374 DMS 3.2 EN 02/2011 TD29 

Base parameters of a CAN module

The Base parameters dialog of a CAN module matches that of the other modules (see

'Base parameters of an I/O Module'Chapter Base parameters of an I/O Module).

IEC addresses by which the PDO’s (Process Data Object) in the project can be

addressed are entered for output and input addresses, whereby the direction (input or

output) is defined from view of the module.

A marker address must be given at the diagnostic address of the CAN module. It works

like described for the CAN master.

CAN parameters of a CAN Module

CAN parameters Dialog for a CAN Module

The CAN parameters of a CAN module, which is not acting as master (global watching

of the bus), are different to those of a CAN master.

Pas de commentaire

Lenze PLC Designer PLC Designer (R2-x) Manuel d'utilisateur Page 376