Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Manuel d'utilisateur télécharger pdf (Page 30)

Opening the ApplicationTemplate

30 Lenze · ApplicationTemplate · 1.3 EN - 04/2013

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7 Opening the ApplicationTemplate

The ApplicationTemplateCounter includes a sample program with three machine modules and a

predefined visualization. The sample program serves to test the basic functions of the

ApplicationTemplate. The sample program in the ApplicationTemplateCounter

( 134)

Standard procedure

The main steps are summarised in the following table:

Detailed commissioning steps

The following section describes the individual commissioning steps in detail.

Follow the instructions specified step by step to commission your automation system.

Step Action

1. Create a new project - open the ApplicationTemplate

( 31)

2. Update the controller in the project (optional)

( 32)

3. Going online

( 33)

• Compiling the project data

( 33)

• Transferring the project to the control - "Log in"

( 33)

4. Loading and starting the PLC program

( 33)

5. Getting started - operating the ApplicationTemplate

( 35)

 Further information on the parameter setting and configuration of the respective bus

system can be found in the following communication manuals (KHB):

• Communication manual EtherCAT: "Controller-based Automation" EtherCAT

• Communication manual CANopen: "Controller-based Automation" CANopen

• Communication manual PROFIBUS: "Controller-based Automation" PROFIBUS

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 176 177

Pas de commentaire

Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Manuel d'utilisateur Page 30