Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manuel d'utilisateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 679
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
9400 HighLine | Parameter setting & configuration
Commissioning
Test commissioning
28 Firmware 1.37 - 09/2006 L
3.2 Test commissioning
Worksteps
Initial commissioning of motor/controller:
1. Select motor in the »Engineer« motor catalog
. (C 66)
When the motor connected to the motor has an electronic nameplate (ENP), all motor data are
automatically read out of the ENP and a selection from the motor catalog is not required. Read the
motor data out of the controller (C 66)
2. Accept/adapt route data
. (C 69)
3. Parameterise motor encoder
. (C 70)
Save project and parameter set:
1. Save parameter set
. (C 57)
2. Save »Engineer« project.
Commissioning of the application:
Note:
The following steps require that the technology application "actuator – speed" has been selected in the
»Engineer« application catalog.
See chapter Technology applications (TAs)
:
Commissioning using the »Engineer«
(C 235)
TA "Actuator – speed"
(C 244)
1. Enable controller via terminal RFR.
2. Enable setpoint follower via digital input DI2.
3. Define speed setpoint via analog input 1 (terminal AI1+/AI1-).
4. If required, the direction of rotation can be inverted via the digital input DI3.
5. Check further Basic drive functions
of the applications:
A quick stop can be activated via the digital input DI1. Quick stop
(C 152)
A manual control is available for the setting-up operation. Manual jog
(C 156)
The enable is executed via the digital input DI6.
The digital inputs DI7 and DI8 activate parameterisable setpoints for both directions of rotation.
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 678 679

Commentaires sur ces manuels

Pas de commentaire