Lenze ETC Motion Control Manuel d'utilisateur télécharger pdf (Page 29)

100

101

Getting started

Establishing the communication between PC and ETCHx

Assigning the IP address of the ETCHx

2.4

2.4.4

EDSTCXN EN 2.0

Like any other device with Ethernet controller, the ETCHx receives an

unchangeable and worldwide unique physical Ethernet address, also called

MAC ID (Media Access Control Identity), from the manufacturer. It can be

used for addressing on the hardware level. The address has a fixed length of

6 bytes (48 bits) and contains an address type, an identification of the

manufacturer and a serial number.

MAC−ID of the ETC: 00:05:7e:xx:xx:xx (with xx:xx:xx = serial number).

The IP address of the ETCHx is specified via the monitor interface.

1. In the HyperTerminal, enter the command ipconf and confirm the

command with <Enter>.

The MAC−ID and the current address setting of the ETCHx are displayed.

ETCM011

2. Press the <Y> key and change the settings. Follow the instructions of

the monitor interface.

Select an IP address according to the rules specified at the beginning of

the section.

The HyperTerminal program can now be quit.

) Note!

Note down the IP address because it must be specified when

creating connections in the ETC−MMI Gateway (¶ 34).

MAC address

Assigning an IP address

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 427 428

Commentaires sur ces manuels

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Lenze ETC Motion Control