Lenze ETC Motion Control Manuel d'utilisateur télécharger pdf (Page 102)

100

101

CNC programming

G functions

G functions individual descriptions

3.2

3.2.2

102

EDSTCXN EN 2.0

3.2.2.4 G04 Dwell time

The preparatory function G04 is used to program the dwell time. In other

words, that the machine is motionless during the programmed time.

G04 X

X: Dwell time in seconds

The dwell time is programmed under the address letter "X", in steps of 0.01 s.

The unit is 1 second.

The minimum time is dependent on the coarse interpolation cycle, the

maximum time is 100 minutes (6000 s).

The modal preparatory functions which were valid before the dwell time

remain effective. In a block with the preparatory function G04, an M function

can still be programmed, which is processed after the dwell time.

N30 G4 X5.1

Allow the dwell time of 5.1 s to pass, then continue with the following block.

Syntax

Meaning of the addresses

Explanation

Example

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 427 428

Commentaires sur ces manuels

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manuel d'utilisateur Page 102

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Lenze ETC Motion Control