Lenze E94AxHE Technology Application Synchronism Manuel d'utilisateur télécharger pdf (Page 53)

EDS94TA10040xxxx EN 1.1 - 10/2008 L 53

9400 Technology applications | Synchronism with mark synchronisation

Parameter setting & configuration

Application error messages

4.13 Application error messages

For the output of application-specific error messages, an FB instance ApplicationError of

the function block L_DevApplErr is available.

r Via the 8 boolean inputs up to 8 different application error messages with

parameterisable module ID, error ID and error response can be activated by the

application.

r The first four inputs can be connected to the multiplexer parameters with the desired

tripping signals. The next four inputs are firmly connected to the tripping signals of the

application.

r Parameter setting: Tab All parameters

Error message Error ID Error response

1 Free (configurable via C03060/1) 8001 Error

2 Free (configurable via C03060/2) 8002 Error

3 Free (configurable via C03060/3) 8003 Error

4 Activate Modulo mode 8004 Warning

5 Following error 8005 Warning

6 Drive cannot follow 8006 No response

7 Drive system interrupted 8007 Quick stop by trouble

8 Reserved 8008 Warning

Parameter Lenze setting

C05900 Module ID 999

C05901/1...8 Error ID 1 ... 8 See table above

C05902/1...8 Error response 1 ... 8 See table above

Control inputs of the function Signal configuration

Lenze setting Control input (Multiplexer parameters)

FALSE  Application fault 1 C03060/1

FALSE  Application fault 2 C03060/2

FALSE  Application fault 3 C03060/3

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 79 80

Pas de commentaire

Lenze E94AxHE Technology Application Synchronism Manuel d'utilisateur Page 53