Lenze CANopen Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 78)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17 78

9 Commissioning of the CANopen Motion bus

9.8 Creating a control configuration

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

9.8 Creating a control configuration

 How to create the control configuration in the »PLC Designer«:

1. Go to the context menu of the target system and use the command Add Device to add

the "CANbus" to the control configuration.

 Note!

The configuration of a Lenze Controller in a CANopen network must be created in the

»PLC Designer«, because the complete configuration is written to the connected slaves

when a controller is started. This process overwrites the previous slave settings.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 109 110

Pas de commentaire

Lenze CANopen Controller-based Automation Manuel d'utilisateur Page 78