Lenze CANopen Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 50)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17 50

8 Commissioning of the CANopen Logic bus

8.9 Setting of CAN parameters and PDO mapping

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

8.9 Setting of CAN parameters and PDO mapping

Set the CAN parameter and the PDO mapping for each Logic device connected to the bus.

 How to set CAN parameters and CAN mapping:

1. Go to the CANopen Remote Device tab of the respective slave.

Use the input field Node ID to set the node address corresponding to the settings in the

field devices:

The following possible settings are only displayed if the Enable Expert Settings option

is ticked.

Make the settings required for your application.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 109 110

Pas de commentaire

Lenze CANopen Controller-based Automation Manuel d'utilisateur Page 50