Lenze CANopen Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 62)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17 62

8 Commissioning of the CANopen Logic bus

8.11 Preparing the restart

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

8.11.3.2 Automatic restart with factory adjustment

 Settings for automatic initialisation with factory adjustment by the Lenze Controller:

1. Enter all desired parameter values under the All parameters tab.

2. Tick "Default settings" under the CANopen Remote Device tab.

When the I/O system has been replaced

1. Set the node address and the baud rate at the code switch.

2. Start the Lenze Controller.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 109 110

Pas de commentaire

Lenze CANopen Controller-based Automation Manuel d'utilisateur Page 62