Lenze CANopen Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 36)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17 36

8 Commissioning of the CANopen Logic bus

8.1 Sample projects (Application Samples)

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

8 Commissioning of the CANopen Logic bus

This chapter provides information for the commissioning of the CANopen Logic field devices in the

Lenze automation system.

Depending on the field devices used, the following Lenze Engineering tools

( 19) are required:

• »EASY Starter«

• »Engineer«

•»PLC Designer«

8.1 Sample projects (Application Samples)

There already exist sample projects (device application + PLC program) for commissioning of Lenze

Controllers.

The Lenze sample projects can be found in the MS Windows start menu under:

Start  All programs  Lenze  AppSamples  ...

The Lenze sample projects can also be opened in the »PLC Designer« via the menu command File 

New project..., or using <Ctrl>+<N>.

 Detailed information on the sample projects can be found in the following

documentation:

• SW_ApplicationSample_i700_(PLC Designer V3)_Vx-y_DE/EN.pdf

• SW_ApplicationSamples_(Controller-based)_Vx-y_DE/EN.pdf

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 109 110

Pas de commentaire

Lenze CANopen Controller-based Automation Manuel d'utilisateur Page 36