Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manuel d'utilisateur télécharger pdf (Page 23)

Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014 23

What is the ApplicationTemplate PackML?

Elements of the ApplicationTemplate PackML

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

An overview of the methods

( 91)

4.3.7 State machine

Each machine module has an own state machine. The state machine of a mode can be created

individually: By deactivating single states in the entire state machine.

More information: State machine in detail

( 65)

4.3.7.1 State transitions - overview

The following status diagram illustrates the possible state transitions of the state machine:

[4-8] State machine in the ApplicationTemplate PackML

The current state of the state machine is highlighted in red.

• Active state in the illustration: "Idle"

• "Idle" corresponds to the "Waiting" state and is thus highlighted in yellow.

The colouring in the state machine distinguishes the following states:

• Yellow: Waiting state

• Green: Acting state

• Blue: Dual state (can be "waiting" or "acting")

The "waiting" states "Stopped", "Aborted" and "Execute" cannot

be deactivated.

Deactivating a state simultaneously switches off the respective (outbound) transitions. If it is the

"Wait" state, it also switches off its "Active" state.

Method Description

Command_UnitMode (eUnitMode:=

L_UserModes_PackML.ExampleMode,

xUnitModeRequest:=TRUE)

Changes over a mode if this is permissible.

Status_ModeChangeAllowed

(L_UserModes_PackML.ExampleMode)

Checks if a changeover of the mode is permissible in the

current state.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 98 99

Pas de commentaire

Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manuel d'utilisateur Page 23