Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 99
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Preconditions
Setting up communication to the Controller
12
Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
•Enter the desired IP address of the controller.
[3-2] Example: Enter the IP address of the Controller, standard setting: 192.168.5.99
3. Click OK to add the controller as gateway.
4. By double-clicking the desired channel (or clicking the Set active path button), set the
channel selected in the device view below the gateway as active path to the controller.
Thus, all communication actions directly refer to this channel.
The currently active path is represented in bold in the list and "(active)" is attached:
5. A device represented in italics is set as active path but has not been found during the last
network scan.
Note!
During initial commissioning, observe the predefined IP address: 192.168.5.99
Further information can be found in the following documentation:
Controller - Parameter setting & configuration
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 98 99

Commentaires sur ces manuels

Pas de commentaire