Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manuel d'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 99
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014 11
Preconditions
System requirements
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3 Preconditions
3.1 System requirements
[3-1] Sample configuration with a Controller 3200 C
3.2 Setting up communication to the Controller
Connect the Engineering PC with the controller via a network cable. The »PLC Designer«
accesses the controller via Ethernet.
Make the IP settings with the »PLC Designer«.
How to check the communication settings:
1. Double-click the desired controller in the Devices view.
2. Make the desired settings on the Communication settings tab.
•Click the Add gateway button to insert a gateway.
Engineering PC Controller
Hardware PC/notebook PLC (Logic) from firmware V3.8
Operating system Windows XP Windows CE
Required Lenze software »PLC Designer« from V3.8
•Contains the
ApplicationTemplate PackML
• Contains the Lenze library
"L_EATP_ApplicationTemplate.co
mpiled-library"
Runtime software
•Logic
Motion (for this purpose, the project
data must be updated: "Update
Device")
Further requirements - Depending on the application case:
• CAN-/EtherCAT bus system
• CAN-/EtherCAT node
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 98 99

Commentaires sur ces manuels

Pas de commentaire