Lenze 8400 Manuel d'utilisateur télécharger pdf (Page 15)

Safety instructions

General safety and application instructions for Lenze motors



EDS84ASC552 EN 9.1

2.2 General safety and application instructions for Lenze motors

(According to: Low-Voltage Directive 2006/95/EC)

General

Low-voltage machines have dangerous, live and rotating parts as well as possibly hot

surfaces.

Synchronous m achines induce voltages at o pen terminals during operation.

All operations serving transport, connection, commissioning and maintenance are to be

carried out by skilled, responsible technical personnel (observe EN 50110-1 (VDE 0105-1)

and IEC 60364). Improper handling can cause severe injuries or damages.

Lowvoltage machines may only be operated under the conditions that are indicated in the

section ”Application as directed”.

The conditions at the place of installation must comply with the data given on the

nameplate and in the documentation.

Application as directed

Lowvoltage machines are intended for commercial i nstallations. They comply with the

harmonised standards of the series IEC/EN 60034 (VDE 0530). Their use in potentially

explosive atmospheres is prohibited unless they are expressly intended for such use

(follow additional instructions).

Lowvoltage machines are components for installation into machines as defined in the

Machinery Directive 2006/42/EC. Commissioning is prohibited until the conformity of the

end product with this directive has been established (follow i. a. EN 60204-1).

Lowvoltage machines with IP23 protection or less are only intended for outdoor use when

applying special protective features.

The integrated brakes mustnotbeused as safety brakes. It cannot be ruled out that factors

which cannot be influenced, such as oil ingress due to a defective Aside shaft seal, cause

a brake torque reduction.

Transport, storage

Damages must be reported immediately upon receipt to the forwarder; if required,

commissioning must be excluded. Tighten screwedin ring bolts before transport. They are

designed for the weight of the lowvoltage machines, do not apply extra loads. If necessary,

use s uitable and adequately dimensioned means of transport (e. g. rope guides).

Remove transport l ocking devices before commissioning. Reuse them for further

transport. When storing lowvoltage machines, ensure a dry, dustfree and lowvibration

eff

 0.2 mm/s) environment (bearing damage while being stored).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 303 304

Pas de commentaire

Lenze 8400 Manuel d'utilisateur Page 15