Lenze Drive Server Bus server S7 getting started Manuel d'utilisateur télécharger pdf (Page 55)

Busserv er S7

116 Busserver S7 DE/EN 1.0

6.6 Example project S7-300 with PROFIBUS-CP

The example project ”LenzeDriveServer” desc ribed in this chapter can be found in the sub-directory

\S7 of the DriveServer installation.

6.6.1 Hardware configuration

• An S7-300 station is used as PLC.

• CPU 315-2 DP, CP 342-5 and power supply PS 307 10A are configured in a RACK 300.

• A PROFIBUS-DP sub-network with master system No. 1 (connected to the CPU) and another

sub-network with master system No. 180 (connected to the CP) are available. The drive

controllers are connected to the second master system.

• Lenze fieldbus modules of type 2133 and 2131 are used as DP slave. These fieldbus modules

can be used for 8200 and 9300 drive controllers.

– PROFIBUS addresses: 4 and 5 (hexadecimal)

– Consistent communication with 8-byte parameter data and 4 process data words

(Configuration ”PAR(Kons.)+PZD(4Worte)”)

The following figure shows the hardware configuration in the Hardware Manager:

Show/Hide Bookmarks

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Pas de commentaire

Lenze Drive Server Bus server S7 getting started Manuel d'utilisateur Page 55