Lenze Drive Server Bus server S7 getting started Manuel d'utilisateur télécharger pdf (Page 48)

Busserv er S7

109Busserver S7 DE/EN 1.0

6.5 Example project S7-400

The example project ”LenzeDriveServer” desc ribed in this chapter can be found in the sub-directory

\S7 of the DriveServer installation.

6.5.1 Hardware configuration

• An S7-400 station is used as PLC.

• CPU 412-2 DP and power supply PS 407 10A are configured in a RACK 400.

• A PROFIBUS-DP sub-network with master system No. 1 and a baud rate of 1.5 Mbit/s is

available.

• A Lenze fieldbus module of type 2131 is used as DP slave. This fieldbus module can be used for

8200 and 9300 drive controllers.

– PROFIBUS address: 9 (hexadecimal)

– Start address of parameter channel: 1000

– Start address of process data channel: 1008

– Consistent communication with 8-byte parameter data and 2 process data words

(Configuration ”PAR(8ByteKons.)+PZD(2Worte)”)

The following figure shows the hardware configuration in the Hardware Manager:

Tip!

The slot table in the Hardware Manager lists the settings of the parameter channel (slot 0) and the

process data channel (slot 1).

The data provided in the columns I-address and O-address are required to call the function FC92 in

the PLC program:

Slot I-address O-address

Show/Hide Bookmarks

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 62 63

Pas de commentaire

Lenze Drive Server Bus server S7 getting started Manuel d'utilisateur Page 48