Lenze DDS Target 9300 Servo PLC V8.x Manuel d'utilisateur télécharger pdf (Page 102)

2.14 STATEBUS_IO (node number 51)

9300 Servo PLC

System blocks

2−96

9300 Servo PLC EN 5.1

2.14 STATEBUS_IO (node number 51)

The state bus is a bus system specifically designed for Lenze controllers/PLCs.

This SB can set the state bus to LOW level and thus set all nodes connected to the state bus to a

previously selected status (e.g. TRIP, quick stop (QSP) or controller inhibit (CINH)).

The SB immediately detects when a node sets the state bus to LOW level and the corresponding

control signal can be processed in the PLC program.

STATEBUS_IO

STATE_BUS_bIn_b

C0441

STATE_BUS_bOut_b

+10V

Fig. 2−30 STATEBUS_IO

Variable

Data type Signal type Address Display

code

Display

format

Note

STATEBUS_bOut_b Bool Binary %QX51.0.4 C0441 bin LOW signal output

STATEBUS_bIn_b Bool Binary %IX51.0.6 − − LOW signal detection

 Every device connected to the state bus can set the state bus to LOW level (multi−master

operation).

 A maximum of 20 devices (controllers/PLCs) can be networked via the state bus.

VU W ST 39 ST PE 28 A4PE

L2L1 L3 PE +UG -UG

9300 Servo PLC / 932X / 933X

VU W ST 39 ST PE 28 A4PE

L2L1 L3 PE +UG -UG

9300 Servo PLC / 932X / 933X

VU W ST 39 ST PE 28 A4PE

L2L1 L3 PE +UG -UG

9300 Servo PLC / 932X / 933X

Fig. 2−31 Networking via the state bus

Stop!

Do not connect an external voltage to terminals X5/ST!

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 168 169

Pas de commentaire

Lenze DDS Target 9300 Servo PLC V8.x Manuel d'utilisateur Page 102