Lenze Function library LenzeIO1000Drv Manuel d'utilisateur télécharger pdf (Page 6)

Function library "LenzeIo1000Drv"

System requirements

6 L DMS 1.0 EN - 07/2011 - TD05

2 System requirements

Software

The function library can be used with the following Lenze software:

Supported target systems

Required libraries for use in »Drive PLC Developer Studio«

with Drive PLC/9300 Servo PLC/ECS:

Unless already available, insert the following libraries into the library management (menu

WindowLibrary management):

 CANopenSdoDrvV10.lib

 LenzeTICan9300V10.lib

 LenzeIo1000DrvV10.lib

 LenzeConversionBoxV10.lib (optional)

Product Type designation Version

Drive PLC Developer Studio ESP-DDS2-x 2.x

PLC Designer V2 2.2 or higher

PLC Designer V3 ESPEVPDxxxxxx 3.x

Product range Type designation Hardware version From software version

Drive PLC EPL-10200 1A or higher 2.x

9300 Servo PLC EVS93xx-EI

EVS93xx-ET

2M or higher 2.x

ECS ECSxA 1B or higher 7.x

9400 ServoPLC E94AxPExxxx 2A or higher 2.x

 Note!

Before the "LenzeTICan9300V10.lib" library is inserted into the library manager,

the CAN_Management system block must be implemented into the Control

configuration.

If the CAN_Management system block is missing or implemented subsequently,

a compilation error may be caused during the project compilation.

Remedy:

Remove "LenzeTICan9300V10.lib" library from the library manager,

implement the CAN_Management system block and re-insert the library into

the library manager.

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Pas de commentaire

Lenze Function library LenzeIO1000Drv Manuel d'utilisateur Page 6