Lenze E94AYCPM Manuel d'utilisateur télécharger pdf (Page 35)

Lenze · E94AYCPM communication module (PROFIBUS®) · Communication Manual · DMS 12.0 EN · 11/2012 · TD17 35

6 Commissioning

6.5 Going online with »Engineer« via TCI

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

2. In »STEP7« in the »HW Config« ...

• create the Lenze PROFIBUS stations with the corresponding station addresses and

•create a PROFIBUS network.

Here a Servo Drive 9400 (address 3) and an Inverter Drive 8400 (address 4) are operated on

the PROFIBUS.

• The names of the PROFIBUS slaves in the »HW Config« must be identical to those of the

corresponding Lenze axes in the »Engineer« (here "9400" and "8400").

• The selection of the process data configuration has no impact on TCI communication.

3. Establish an Ethernet connection to the PROFIBUS CPU.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 124 125

Pas de commentaire

Lenze E94AYCPM Manuel d'utilisateur Page 35