Lenze c300 Manuel d'utilisateur télécharger pdf (Page 72)

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17 72

10 Device replacement - replacing the controller (in the event of

service)

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

10 Device replacement - replacing the controller (in the event of service)

Condition

Principally, a defective Controller can only be replaced by a device of the same product type.

Which replacement device is suitable for the Controller?

( 73)

10.1 Removing the connected (defective) controller

 How to remove the connected controller:

1. Disconnect the system from the supply and check for correct disconnection.

2. Disconnect the current supply of the controller.

3. If I/O modules (I/O system 1000) are connected to the Controller:

Remove electronic module of the first I/O system 1000 (if available)

4. Remove bus connections and other connections.

5. Remove SD card from the card slot.

 Danger!

High electrical voltage

De-energise the controller before

removing a connected controller.

 Mounting instructions for the Controller or I/O system 1000 (EPM-Sxxx)

Here, further information on mounting can be found.

Observe the safety instructions contained therein!

 System manual for I/O system 1000 (EPM-Sxxx)

Here, further information on the single modules of the I/O system can be found.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 194 195

Pas de commentaire

Lenze c300 Manuel d'utilisateur Page 72