Lenze E84DGFCR Manuel d'utilisateur télécharger pdf (Page 32)

Communication manual 8400 motec PROFINET

Commissioning

Setting the IP configuration

32 L EDS84DMOTPNET EN 2.0 - 11/2011

2. By double-clicking on the individual IP parameters, you can set the IP configuration

for each PROFINET node in the Configure nodes dialog window.

3. Click Transferred.

• The IP configuration is transferred to the corresponding PROFINET node.

• Changes in the IP parameters will become effective immediately.

• The IP parameters are written to codes C13000

(IP address), C13001 (subnet

mask), and C13002

(gateway address) of the Communication Unit.

 Tip!

By clicking the Find device button in the Assign IP addresses dialog window (see

step 1), you can check whether the configuration was transferred successfully.

With device command C00002 = "11: Save all parameter sets", the current IP

configuration is saved non-volatilely in the memory module.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 89 90

Pas de commentaire

Lenze E84DGFCR Manuel d'utilisateur Page 32