Lenze PROFINET Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 12)

4 The Lenze automation system with PROFINET

12 Lenze · Controller-based Automation · PROFINET® Communication Manual · DMS 1.2 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

4 The Lenze automation system with PROFINET

This chapter provides basic information about ...

• the structure of the Lenze automation system using the PROFINET bus system;

• the Lenze Engineering tools required for commissioning;

• the interaction of the components.

We recommend using PROFINET for the following applications:

• Equipment and extension of system parts that have already been automated with PROFINET

before.

• Use of field devices that are not available for e.g. EtherCAT, CANopen or PROFIBUS.

• The combination of PROFINET with EtherCAT is possible.

 Tip!

Detailed information about PROFINET can be found on the website of the PROFIBUS &

PROFINET user organisation:

www.profibus.com

 Note!

• In the Lenze automation system, no PROFINET master functionality is supported. In a

PROFINET network, a Lenze Controller can only be driven as I/O device (slave), e.g. by

a Siemens SIMATIC S7 PLC.

• In the Lenze automation system, Logic field devices can be exclusively operated via

PROFINET. Thus, as an I/O device, the Lenze Controller is a Logic field device.

• The motion functionality is not supported when PROFINET is used. Always use

EtherCAT to connect inverters to be controlled via the central Motion functionality.

Mixed operation PROFINET with EtherCAT

( 32)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Pas de commentaire

Lenze PROFINET Controller-based Automation Manuel d'utilisateur Page 12