Lenze PROFIBUS Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 15)

Lenze · Controller-based Automation · PROFIBUS® Communication Manual · DMS 4.3 EN · 04/2014 · TD17 15

4 The Lenze automation system with PROFIBUS

4.1 Brief description of PROFIBUS

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

4.1.1 Structure of the PROFIBUS system

[4-1] Example: PROFIBUS with the 3231 C Lenze Controller (I/O system 1000 and Servo Drive 9400 as slaves)

In the example (Fig. [4-1]), the 3231 C Lenze Controller is the PROFIBUS master. It can communicate

with one or several stations (slaves).

PROFIBUS has an internal line topology (without repeater) or a tree topology (with repeater).

Basic wiring of PROFIBUS

( 17)

The PROFIBUS network must be terminated at the first and last station. The bus terminating resistor

is integrated into the bus connector and is activated by a switch.

Using the Lenze Controller as a PROFIBUS slave

Using the MC-PBS communication card, the Lenze Controllers can also be applied as PROFIBUS

slaves.

 Tip!

A sample project for operation of a 3200 C controller as PROFIBUS slave can be found in the

"Download" area at www.Lenze.com

Application Knowledge Base: All articles  Application Ideas Pool  Controller 3200 C

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 54 55

Pas de commentaire

Lenze PROFIBUS Controller-based Automation Manuel d'utilisateur Page 15