Lenze HMI for visualisation / with control technology Manuel d'utilisateur télécharger pdf (Page 27)

Mechanical installation

Mounting steps



LDCDS−EL100 EN 9.0

5.2 Mounting steps

EL100−004

How to assemble the HMI:

1. Cut the mounting cutout out of the control cabinet door.

2. Assemble the upper screw clamping fixtures (see figure).

3. Check if the gasket under the front panel is located correctly.

4. Insert the device into the mounting cutout, secure it by hand against falling down

and tighten the assembled screw clamping fixtures hand−tight.

5. Secure the device by hand, assemble the remaining screw clamping fixtures and

tighten them hand−tight.

6. Check if the device is securely located in the mounting cutout and if the front panel

gasket is located correctly.

– If necessary, loosen the screw clamping fixtures, re−align the device or gasket and

tighten the screw clamping fixtures hand−tight.

– If the gasket is not located correctly, protection class IP65 is not reached on the

front of the device!

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 95 96

Pas de commentaire

Lenze HMI for visualisation / with control technology Manuel d'utilisateur Page 27