Lenze Controller-based Automation Manuel d'utilisateur télécharger pdf (Page 62)

8 Appendix

8.1 Communication by means of OPC

Lenze · Controller-based Automation · System Manual · DMS 1.4 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

8.1.4 OPC tunnel

If an OPC server and an OPC client are located on different computers, OPC tunnels are used. This is

a software which is installed on both computers and which acts as client/server itself.

The OPC tunnel for example uses the TCP/IP protocol to transfer the data between the OPC server

and OPC client. OPC tunnels provide for a cross-platform and cross-network communication of OPC-

based applications.

OPC tunnels are the basis for communication...

• between the engineering PC and the Controller (e.g. establishing communication in the »PLC

Designer«, »VisiWinNET®«) Engineering tools.

• between the Controller and other (remote) computers.

[8-1] * The PROFIBUS fieldbus driver can only be accessed via PLC (Logic/Motion). Access via »EASY Starter« or »VisiWinNET®«

Runtime is not provided.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68

Pas de commentaire

Lenze Controller-based Automation Manuel d'utilisateur Page 62