Lenze HMI Designer Getting Started Manuel d'utilisateur télécharger pdf (Page 40)

HMI Designer

EDBHMI-DEEN DE/EN 4.0

QKRKP aÉíÉêãáåÉ ÅçããìåáÅ~íáçå é~ê~ãÉíÉêë

The keypad and the controller communicate via the system bus (CAN). Define the communication

parameters for both devices, before the project is transmitted to the keypad.

`çããìåáÅ~íáçå é~ê~ãÉíÉêë çÑ íÜÉ ÅçåíêçääÉê

• Mark the component 93xx in the project area and select Edit  Parameters to open the

Device’s parameters dialog box:

• Enter the controller address in the Device’s properties dialog box.

Ó The controller address is saved under code C0350 (CAN bus node address).

• Confirm with OK.

qáé>

The value set under Controller address must be identical with the setting in the controller.

( Operating Instructions “9300 Servo inverter” or online documentation “9300 Servo PLC” on the CD-ROM “Drive

PLC Developer Studio”)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 49 50

Pas de commentaire

Lenze HMI Designer Getting Started Manuel d'utilisateur Page 40