Lenze EVS93xx Manuel d'utilisateur Page 25
- Page / 46
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Loading a parameter set
3
25
EDKVS93−02 EN 3.0
3.1.5 Loading a parameter set
The keypad serves to load a saved parameter set into the main memory when the controller
is inhibited. After the controller is enabled, it operates with the new parameters.
Danger!
ƒ When a new parameter set is loaded, the controller is reinitialised and acts
as if it had been connected to the mains:
– System configurations and terminal assignments can be changed. Make
sure that your wiring and drive configuration comply with the settings of
the parameter set.
ƒ Only use terminal X5/28 as source for the controller inhibit! Otherwise the
drive may start in an uncontrolled way when switching over to another
parameter set.
Note!
ƒ After switching on the supply voltage, the controller always loads parameter
set 1 into the main memory.
ƒ It is also possible to load other parameter sets into the main memory via the
digital inputs or bus commands.
Step Key
sequence
Action
1. Inhibit controller Terminal X5/28 = LOW
2. Load the saved parameter set into the
main memory
A ! " # Select the code C0002 "PAR LOAD" in the menu
"Load/Store"
B Change to the parameter level
The active parameter set is displayed, e. g. display "0"
and "Load Default"
If you want to restore the delivery status, proceed with
D
Select the parameter set to be
loaded
C Load parameter set 1:
ð Set "1" "Load PS1"
Load parameter set 2:
ð Set "2" "Load PS2"
Load parameter set 3:
ð Set "3" "Load PS3"
Load parameter set 4:
ð Set "4" "Load PS4"
D "RDY" goes off. The parameter set is loaded completely
into the main memory if "RDY" is displayed again.
3.
Change to the code level
A Display of the operating level
B Display of C0002 "PAR LOAD"
4. Enable controller Terminal X5/28 = HIGH
The drive is running with the settings of the loaded
parameter set
- 9300 15 ... 30 kW 1
- 9300std079 2
- Status displays 3
- Key for overview 3
- Connections and interfaces 3
- Contentsi 4
- About this documentation 5
- 1 About this documentation 5
- 2 Safety instructions 9
- Safety instructions 10
- Warnings! 15
- Parameter setting 19
- 3 Parameter setting 19
- Danger! 25
- EDKVS93−02 EN 3.0 32
- EDKVS93−02 EN 3.0 33
- 9300std230 34
- Troubleshooting 35
- System error messages 37
- General error messages 37
- ' ( 46
Produits connexes et manuels pour Matériel Lenze EVS93xx
Matériel Lenze ECSCExxx Manuel d'utilisateur
(164 pages)
(164 pages)
Matériel Lenze SS208AC Manuel d'utilisateur
(31 pages)
(31 pages)
Brocade Communications Systems SilkWorm 3200 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Computerzubehör Brocade Communications Systems SilkWorm 3200.
Wir stellen 1 PDF-Handbücher Brocade Communications Systems SilkWorm 3200 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Commentaires sur ces manuels