Lenze E94AMHE Manuel d'utilisateur télécharger pdf (Page 83)

Wiring the device modules

Safety modules



EDK94AMH24 DE/EN/FR/ES/IT 3.1

Addressing

The safety address serves to clearly assign the safety modules of the SM301 type in systems

with several drives. The address "0" is not permissible.

Address switch

The safety address can be set in the left part of the housing by means of the DIP switch .

For setting the switch, use an appropriately small tool, e. g. a probe. The switch can only be

set if the module is not connected to a standard device. Via the switch, addresses in the

range of 0 ... 1023 can be set. Alterations by the switch with regard to the address are only

activated when the 24−V supply is switched on. The address setting "0" requires the setting

by the address code.

DIP switch  Labelling

1 2 3 4 5 6 7 8 9 0

Value of the address bit 1 2 4 8 16 32 64 128 256 512

 Note!

In the SM301 safety module as of version VA 1.xx, the address 0 is replaced as

follows:

ƒ With the address saved in the safety module in the parameter

"Safety address" (C15111).

ƒ If the address 0 canot be replaced, the module reports an error.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 213 214

Pas de commentaire

Lenze E94AMHE Manuel d'utilisateur Page 83