Lenze IM94MV01C Manuel d'utilisateur

IM94MV01CMotionViewConfiguration and Programming SoftwareUSER’S MANUAL

8 IM94MV01C1.4.1 Connection using PPP over RS-232/RS4851. The first time in a session, click [Project] then [Connection Setup] or click the [ ] icon

IM94MV01C 9Select [Control Panel] from the Start menu.Figure 10b: Network ConnectionsSelect [Network Connections] in the Control Panel menu.Select

10 IM94MV01CUnder the General tab, select [Internet Protocol (TCP/IP)]. Figure 10d: Internet Protocol TCP/IPClick [Properties].Select [Use the follow

IM94MV01C 112. Configure IP Address of Drive:3. The first time in a session, click [Project] then [Connection Setup] or click the [] icon and sele

12 IM94MV01C1.5 Build RS-485 Connection ListFigure 11: Build RS 485 Connection ListNow This window shows a list of drives currently connected.To be

IM94MV01C 131.7 File Operations1.7.1 Opening and Closing Parameter Files.To open an existing configuration file, click [Node] on the main menu th

14 IM94MV01C2.2 MotorAfter configuring the interface of the PositionServo drive, the motor needs to be setup if one is attached. To select a motor,

IM94MV01C 15Table 3: E94P09T4N Drive ParametersParameter Name Value Units Min MaxDrive nameDrive mode TorqueDrive PWM frequency 16kHzCurrent limit

16 IM94MV01C2.4.2 RS485 and ModbusThe [RS485 and Modbus] folder contains the configuration parameters of the Modbus interface. Click on any Modbus p

IM94MV01C 172.5.2 Analog I/OThe [Analog I/O] folder contains the parameters of one output and one input plus an action button [Adjust analog inpu

18 IM94MV01C2.8 Indexer ProgramClick on the [Indexer program] folder to open the MotionView Studio (the List View window is gray when MotionView Stu

IM94MV01C 19Figure 16: Oscilloscope DisplaySignal NameYou can customize the information presented by the Scope tool by choosing the drop-down box

20 IM94MV01CAlways on top Select this button to display the oscilloscope window on top all other windows.Options Select this button to change the cha

IM94MV01C 21AC Technology Corporation • 630 Douglas Street • Uxbridge, MA 01569 • USA +1 (508) 278-9100

IM94MV01C 1                                            

2 IM94MV01CSafety Warnings WARNING!• Hazard of unexpected motor starting! When using MotionView software, or otherwise operating the P

IM94MV01C 3 MotionView is the setup and management tool for SimpleServo and PositionServo Drives. The user interface

4 IM94MV01C1.2 Main ScreenThe user interface or Motion View main screen consists of 3 main panels: the Node Tree, the List View, and the Message Win

IM94MV01C 51.2.4 How to Change ParametersTo change any parameter, click on the parameter of interest on the list view. The dialog box opens and t

6 IM94MV01CSome groups from the Node Tree have Action buttons in the List View. They will perform the action listed against the buttons in the list v

IM94MV01C 71.3 Managing ProjectsMultiple parameter files and drives can be opened at the same time. Information about which files and drives are op